SHENMAO Addresses HoP Issues, Improves ICT Testability


Reading time ( words)

SHENMAO Technology Inc. will introduces its new generation PF606-P140 lead-free solder paste and PF606-P245 lead-free zero-halogen solder paste at the upcoming SMTA International Exhibition, to be held September 19–20, 2017 at the Donald Stephens Convention Center in Rosemont, Illinois. SHENMAO will be in Booth 534.

Featuring superior continuous high-speed printability and a wide reflow process window for excellent solderability, the PF606-P140 and PF606-P245 prevent head-on-pillow (HoP) issues and can easily fit into highly complicated PCB designs through excellent convergence performance. The PF606-P140 features void performance at 3.7%, while the PF606-P245, 5.5%.

The PF606-P140 and PF606-P245 improve ICT testability with flux completely removed from top of solder to prevent contamination of test pins during test operation. Minimal flux residue gathers near outside of solder joint on the PCB substrate, a substantial improvement over legacy solder pastes.

About SHENMAO

For more than 44 years, SHENMAO has been dedicated to produce solder products including water soluble and no-clean solder paste, laser solder paste, solder preforms, cored solder wire, wave solder bar alloys, wave soldering fluxes, extremely pure solder powder up to Type 8, BGA and micro-BGA solder sphere, wafer level packaging solder paste and fluxes, LED die attach paste, high performance liquid fluxes, solder preform, solar ribbon, and plating anode used in PCB fabrication, assembly and semiconductor packaging processes.

SHENMAO solder materials are available at affordable cost from 10 worldwide locations.

For more information, visit www.shenmao.com.

Share


Suggested Items

Indium's Karthik Vijay Talks Engineering for Automotive Applications

01/22/2018 | Barry Matties, I-Connect007
Barry Matties met with Karthik Vijay, Indium Corporation's technical manager for Europe, at last year's productronica, where everything from stencils and laser cutting to flux technology and jetting were discussed. If you want to know about where material technology currently stands in the automotive landscape, you’ll want to read on.

PCB Pad Repair Techniques

01/08/2018 | Bob Wettermann, BEST Inc.
There are a variety of reasons behind pads getting "lifted" completely or partially from the laminate of a PCB. Per the just revised IPC-A-610 Revision G, a defect for all three classes occurs when the land is lifted up one or more pad thicknesses. Lifted pads can occur when a device has been improperly removed or there is a manufacturing defect in the board construction. In any case, as with any repair, the ultimate decision on the ability to repair the pad lies with the customer.

Top 10 Most-Read SMT007 Columns of 2017

01/02/2018 | I-Connect007
Another year is over in the SMT industry. 2017 saw a myriad of hot topics, including Industry 4.0, the millennials’ entry into the manufacturing space, and alternative solder materials, to name a few. Without further ado, here are the Top 10 columns from SMT007 over the past year.



Copyright © 2018 I-Connect007. All rights reserved.