Reading time ( words)
The October issue of The PCB Magazine has published and is now available.
Current Trends in Signal Integrity
If you think signal integrity is just a design problem, think again. As board features get smaller, as speeds get faster, and as more is expected from everyone in the supply chain, signal integrity should have everyone’s attention. This month, our experts explain why.
Check it all out this month in The PCB Magazine, now on the virtual newsstand and available for delivery in your e-mailbox each month by subscribing here.
You can also download the pdf version to your devices for future reference.
This new book by Stephen Denning addresses the issue of change and adaptability like no other book I have read thus far…and I read a lot of business books! Centering on meeting the challenges of new and often changing business environments and how to meet them, the author’s focus on agility runs from the power of smaller teams that are focused on solving problems quickly while eschewing the normal bureaucratic road blocks that have been in place for decades.
Bob Burns, PRINTED CIRCUITS
One question that I hear fairly often, particularly after an initial quotation, is “Why is rigid-flex so expensive?” In this article, I’ll share with designers the cost drivers in rigid-flex relative to standard rigid boards and flex circuits with stiffeners. A typical rigid-flex PWB will cost about seven times the cost of the same design on a hard board, and two to three times an equivalent flex circuit with stiffeners.
No matter what business you are in, whether it be retail or B2B, you’re going to be able to benefit from everything in this book. It is without a doubt the best customer service training book on the market today.