Tips & Tricks: Rule-Based PCB Layout


Reading time ( words)

Design rules are rules set in your PCB CAD software that will do one or more of two things. First, they set the limits of the capabilities of the PCB fabrication company you'll use to make your blank PC boards. For example, if your fab house has a minimum trace and space of 5 mils, your design rules, and a design rule check, will ensure that none of your traces or spaces are too small for their processes.

Next, they can be used for rules-based design. Some software will automatically size traces based on the design rules you set ahead of time. With this type of software, if you want all of your power and ground traces to be 16 mils, you set a net class with a width of 16 mils, and assign the power and ground nets to that net class. The software would automatically make any power and ground nets 16 mils wide.

Your design rules will be a crossover between what you need and what your fab house can produce. Some more primitive CAD software will require that you manually pick the width for a via or copper trace, if you want it to differ from the default. Other software, as noted above, will let you set up a series of design rules, and will pick widths based on those rules.

For example, you might specify that power and ground traces are 16 mils in width and standard signal traces are 8 mils wide. The CAD system would then default to those widths when you picked a net in that net class. The net is the connection, like from Pin 7 of chip U2, to Pin 1 of capacitor C3. The net class would be the type of net, like power or ground, or signal.

You’ll need to refer to your fab house, both to ensure that they can build what you need, and to get the final say on their design rules. Some fab houses even have downloadable design rules for various CAD packages. That makes setting things up a lot easier.

Duane Benson is the Chief Technology Champion at Screaming Circuits, a prototype PCB assembly electronic manufacturing company in Canby, Oregon.

Share


Suggested Items

Excerpt: The Printed Circuit Designer’s Guide to…Flex and Rigid-Flex Fundamentals

06/20/2018 | Dave Lackey and Anaya Vardya, American Standard Circuits
The design process is arguably the most important part of the flex circuit procurement process. The decisions made in the design process will have a lasting impact, for better or worse, throughout the manufacturing cycle. In advance of providing important details about the actual construction of the flex circuit, it is of value to provide some sort of understanding of the expected use environment for the finished product.

Faster Board Speeds Demand Constraint-Driven Design

06/19/2018 | Ralf Bruening, Zuken
Using powerful constraint techniques can be a double-edged sword. While the design process is made much safer by including constraints, it is all too easy to over-constrain the design and make it impossible to complete routing and placement. Even paper design guidelines can make products uneconomic to produce unless a great deal of engineering knowledge is applied during the design.

Making the Most of PCB Materials for 5G Microwave and mmWave Amps

06/13/2018 | John Coonrod, Rogers Corporation
Ready or not, 5G is coming, and it will require the right circuit materials for many different types of high-frequency circuits, including power amplifiers. 5G represents the latest and greatest in wireless technology, and it will be challenging to design and fabricate, starting with the circuit board materials, because it will operate across many different frequencies, such as 6 GHz and below, as well as at millimeter-wave frequencies (typically 30 GHz and above).



Copyright © 2018 I-Connect007. All rights reserved.