Zestron's pH-Neutral Defluxing Agent to be Featured at SMTA Monterrey


Reading time ( words)

Zestron, a provider of high-precision cleaning products, services and training solutions in the electronics manufacturing and semiconductor industries, will feature VIGON N 680 at the SMTA Monterrey Expo.

VIGON N 680, based on the MPC Technology (Micro Phase Cleaning), is a water-based, pH neutral cleaning agent specifically developed for the use in spray-in-air inline and batch equipment. VIGON N 680 removes a broad range of electronic assembly flux residues with an exceptional ability to penetrate and clean under low standoff components.

The SMTA Monterrey Expo and Tech Forum will be held at the Crowne Plaza in Monterrey, Mexico on September 12. For more information or to register, please click here.

About ZESTRON

Headquartered in Manassas, Virginia, and operating in more than 35 countries, ZESTRON is the globally leading provider of high precision cleaning products, services and training solutions for the electronics and semiconductor manufacturing industries. With eight worldwide technical centers and the largest team of engineers focused on high precision cleaning, ZESTRON’s commitment to ensuring that its customers surpass even the most stringent cleaning requirements is without equal.

For additional information and to tour one of our unparalleled technical centers, please click here.

Share

Print


Suggested Items

Tips & Tricks: Water Contamination and Flux Expiry

04/17/2019 | Jason Fullerton, MacDermid Alpha Electronics Solutions
Solder joints that form properly are not expected to exhibit reduced reliability. However, a higher number of defects created tends to lead to a higher chance that defective connections escape detection through inspection and functional testing, and that’s not a risk to be taken lightly.

Bill Cardoso Discusses Creative Electron’s Inspection Strategy

04/03/2019 | Tim Haag and Barry Matties, I-Connect007
At PCB West in Santa Clara, California, Dr. Bill Cardoso of Creative Electron held a class on advanced packaging and X-ray inspection strategy. Guest Editor Tim Haag and Publisher Barry Matties met with Bill to further discuss his class and the importance of turning inspection data into information.

Tips & Tricks: Wave Solder Bridging

04/03/2019 | Jason Fullerton, MacDermid Alpha Electronics Solutions
Wave solder bridging is the most difficult defect to troubleshoot because it has a number of potential causes. The key is to understand the role of flux during wave contact—thus reducing the surface tension of the solder to reduce the tendency to bridge between pins as the board leaves the wave.



Copyright © 2019 I-Connect007. All rights reserved.