Joe Clark Discusses DownStream’s Updated Tool Lineup and IPC-2581


Reading time ( words)

DownStream Technologies recently revamped their entire product line, from CAM350 through BluePrint-PCB. DownStream co-founder Joseph Clark and Guest Editor Kelly Dack discuss some of these updates, including a new GUI and capabilities such as 3D analysis, as well as news about IPC-2581.

To watch this interview, click here.

Share

Print


Suggested Items

A Drone's-eye View of the IPC APEX EXPO Show Floor

02/14/2019 | Real Time with...IPC
If you couldn't make it to IPC APEX EXPO in San Diego, don't worry. We have full coverage of this annual must-attend event, from the opening ceremony to the close of the final day. To get a sense of the size of this year's show, check out our drone's-eye view of the show floor. Can we name our drone Air007?

RTW IPC APEX EXPO 2019: For Elmatica, the Future is All About Data

01/30/2019 | Real Time with...IPC
At this year's IPC APEX EXPO, guest editor Judy Warner sits down with Elmatica CEO Didrik Bech to discuss the company's business model and CircuitData, their award-winning open-source PCB design data language.

The Designers Council: A Chapter Primer From the Ground Up

01/29/2019 | Scott McCurdy, Freedom CAD Services
Thinking it might be a way to make new contacts with PCB designers in Orange County, I attended a couple of Designers Council meetings. The chapter president at that time was Paul Fleming, who asked me to be part of his steering committee because he learned that I had spent decades in fabrication. Within a few months, he had gotten a job transfer to Arizona, so he twisted my arm to take over as the chapter president. I agreed, but little did I know that this would become a major turning point in my PCB career.



Copyright © 2019 I-Connect007. All rights reserved.