RTW IPC APEX EXPO 2019: MacDermid Alpha on Affinity for ENIG


Reading time ( words)

John Swanson, director of final finishes for MacDermid Alpha Electronics Solutions, speaks with I-Connect007 Guest Editor Kelly Dack about the ENIG finish process and their new product Affinity, which smooths out the challenges of the process.

To watch the interview, click here.

Share

Print


Suggested Items

Standards: Why We Have Them and Live by Them

10/07/2019 | Alifiya Arastu, Jeff Beauchamp, Harry Kennedy, and Ruben Contreras, NCAB GROUP
Have you ever designed a board but received feedback that it couldn’t be manufactured unless changes were made? Or maybe you’ve designed a complex board and sent it to the factory only to find out that the manufacturer didn’t build the board to your expectations? PCBs are becoming more complex, factory options are growing, and expectations for product life cycles are becoming longer.

A Guide to High-reliability PCBs from Design to Specification

07/24/2019 | Jeff Beauchamp, NCAB Group
Creating reliable PCBs is an outcome of considering all aspects that can affect reliability as early as possible in the design process. The further down the design process, the more expensive and risky it can be to fix. As they say, everything starts with the design. Because a good board design improves the reliability of the end product and lessens the risk of failure.

Identifying Product Board Class and Pre-quote Software

07/09/2019 | Mark Thompson, CID, Prototron Circuits
Deciding on the class of the final product will determine what files are needed for fabrication and assembly. It is critical to note that for a product to be built to any class level, it must be designed to that class level from its inception.



Copyright © 2019 I-Connect007. All rights reserved.