Words of Advice: Where Do You Get Involved in the Design Process?


Reading time ( words)

In a recent survey, we asked the following question: Where in the process do you typically get involved with a design project? Here are a few of the answers, edited slightly for clarity.

  1. At the schematic.
  2. Making library parts, and then generally not until most of the schematic is complete.
  3. During layout.
  4. During planning.
  5. When “they” decide what it is that “they” want.

Share

Print


Suggested Items

Designing for Complex PCBs

12/12/2019 | I-Connect007 Editorial Team
The I-Connect007 editorial team sat down with Freedom CAD’s Scott Miller to talk about the industry’s demand for more increasingly complex PCBs, and the challenges this presents. They also discuss Freedom CAD’s in-house training programs, the company’s recent book authored by Scott, and why communication is such an important tool in a PCB designer’s toolbox.

A Radical New Design Perspective

11/21/2019 | Nolan Johnson, PCB007
Nolan Johnson recently interviewed Gordon Kruberg, CEO of Gumstix, which was acquired by Altium recently. While Gumstix designs and sells computer hardware products, Altium bought Gumstix for the Geppetto design software. Gordon discusses how the concepts of Geppetto are likely to influence future design methods in the Altium environment.

Communication, Part 6: The Importance of Technology Fit

11/08/2019 | Steve Williams, The Right Approach Consulting LLC
In the final installment of this series on how PCB fabricators and designers can better communicate, Bob Chandler from CA Design and Mark Thompson from Prototron Circuits discuss the importance of “technology fit” and how this concept impacts the synergy of the two parties involved.



Copyright © 2019 I-Connect007. All rights reserved.