EPTE Newsletter: Monocoque Printed Circuits, Part 2


Reading time ( words)

Editor’s Note: Dominique Numakura first covered monocoque printed circuits in a column from May 2019.

What would you think if electronic circuits could be built directly on a polyethylene terephthalate (PET) package of strawberries and birthday cakes? It was a dream for electronics engineers to draw 3D circuits directly on the surface of the housing or packages of products. The idea behind molded interconnect device (MIDs) was created about 30 years ago to satisfy this dream. Several new processes, such as laser engraving and inkjet printing, have been proposed to build electronic circuits on 3D-structured objects. Unfortunately, no one was very successful with it as a popular circuit technology because of the technical and economic difficulties.

Wiring with flexible circuits could be a practical solution. Nowadays, most mobile device manufacturers are consuming huge amounts of thin, flexible circuits to attach on the surface of the housing in limited spaces. However, the cost of flexible circuits and assembling them is another headache for device manufacturers because they are not negligible in the whole cost of the devices.

Now, a new idea has been created in Taiwan to build 3D printed circuits. It looks like an egg of Columbus, and the manufacturing process is very simple. Firstly, a silver-based thick-film circuit is printed on a thermoplastic sheet, such as PET. The baking temperature of the circuit must be lower than the melting temperature. It depends on the capability of the circuit manufacturer, but double-layer circuits with via holes are available.

To read this entire column, which appeared in the September 2019 Flex007 section of Design007 Magazine, click here.

 

Share

Print


Suggested Items

PCB Surface Preparation Before Solder Mask on Non-copper Finishes

04/08/2020 | Nikolaus Schubkegel
A circuit board is made of copper. Usually, final finishes are applied after the solder mask process. In some cases, for special applications, the final finish may be applied before solder mask. In this case, we have solder mask on ENIG or galvanic nickel-gold. It is also possible to have tin or tin-lead under solder mask; this was an old technology that no longer plays a role today.

The Direction of MacDermid Alpha’s Automotive Initiative

04/02/2020 | Nolan Johnson, I-Connect007
Nolan Johnson speaks with Lenora Clark about MacDermid Alpha’s automotive initiative, where her role fits into the company’s focus on supporting carmakers in various business areas, and where the future of automotive is heading.

XRF: An Essential Tool to Help PCB Manufacturers Meet IPC Specifications

03/04/2020 | Matt Kreiner, Hitachi High-Tech
One of the main challenges in PCB manufacturing is to create a stable, long-term coating of the copper surface to perform critical functions throughout the expected lifetime of the part. The surface coating is there to do two things: prevent the copper from oxidizing by coming in contact with the air and form a reliable contact for a soldered joint or wire-bonded connector.



Copyright © 2021 I-Connect007. All rights reserved.