Everything You Wanted to Know, But Were Afraid to Ask


Reading time ( words)

This month, Testing Todd presents readers’ questions about the basics of electrical test, including the different types of testing available today.

 

Reader: I recently found out that all points are not necessarily checked during electrical test. Why is that and which types of boards do not get all of their points tested? Isn’t there a chance that something will be missed? Is there a type of test that hits all of the points?

Todd: When a board is programmed for test, certain points of the board are de-selected. To properly answer this question, we need to revisit IPC-9252A, Amendment 1, which stipulates that Class I and II can remove the mid-points of a net on the board. What this means is that we are only concerned with the end-to-end connectivity of the net. With IPC Class III we need to include the mid-points of the net to quickly isolate any problems in the chain. However, this is cautioned by the additive properties of solder mask encroachment or via-fill. In these cases, although Class III, they cannot be tested and are allowed the waiver under the 9252A with Amendment 1 release.

Within the Class III requirement of 9252A with Amendment 1, we can add probes to validate each landing pad. With Class I and II we are only validating the end points of the net to make sure the signature is intact. By adding mid-points with Class III we validate that the connectivity is valid to all landing pads. This is in case there may be contamination to any of the intermediate landing pads in the chain of the net.

Adding all pads in the net is referred to as Class III per IPC-9252A with Amendment 1, which hits all of the points.

Read the full column here.


Editor's Note: This column originally appeared in the May 2014 issue of The PCB Magazine.

Share


Suggested Items

In Terms of Experience, a 10,000-foot View of China

01/17/2018 | Barry Matties, I-Connect007
In the past 30+ years of PCB manufacturing in China, you would be hard-pressed to find someone more connected to the pulse of the Asian market than Gene Weiner. Barry Matties met with the industry veteran at HKPCA to get his take on the show, the current and future market conditions of China, and any effect the new U.S. administration might have on trade relations going forward.

Weiner’s World—December 2017

01/02/2018 | Gene Weiner, Weiner International Inc.
Hold on to your seats! 2018 will be a year full of rapid changes, surprises, and growth. M&A activities will flourish. The supply chain will suffer shortages and changes as demand increases, copycats will rush to market, and new markets and potential suppliers will vanish before they are established.

AGFA: From Film to Inkjet Solder Mask

12/20/2017 | Patty Goldman, I-Connect007
The productronica show was indeed filled with new technology, and it was great to meet with people and learn about it. This is precisely how I met AGFA’s Frank Louwet, who filled me in on the Dipamat inkjet solder mask they have been developing. It seemed an odd choice to go from film to solder mask, but as Frank explained, it makes perfect sense.




Copyright © 2018 I-Connect007. All rights reserved.