Tin Whiskers: Concerns & Potential Impact


Reading time ( words)

What is the biggest concern about the growth of tin whiskers? A simple answer is “uncertainty.”

Electronic system failures attributing to or related to whiskers have been reported in the past before the electronics industry was converted to lead free. With the elimination of the use of lead (Pb) in electronics in compliance with worldwide RoHS regulations, Pb-free materials including pure tin (Sn) have been used as surface coating for component leads and metal terminals, and as solder materials in making solder joints.

Pure tin makes a practical replacement to Sn-Pb as a choice of surface coating because of its economics, availability, and performance in manufacturability, compatibility, and solderability. Today, most component manufacturers offer pure tin-coated components.

On electronic system failure, as an illustration, one of the well-studied and highly publicized incidents was the TOYOTA Camry 2003 model investigation. The unintended acceleration of the vehicle speed control was reported in 2009. National Highway Traffic Safety Administration (NHTSA) initiated an investigation with the technical support of NASA Engineering and Safety Center. Destructive physical analysis of a failed accelerator pedal position sensor assembly from a consumer vehicle that was identified with a diagnostic trouble code found the presence of tin whiskers. A tin whisker had formed a 248 Ω resistive short between two terminals of the accelerator pedal position sensor of its potentiometer accelerator pedal assembly. A second tin whisker of similar length grew from a 5-volt source terminal adjacent to a pedal signal output terminal, but this whisker did not make contact with any other terminals at the time of the analysis.

Read the full column here.


Editor's Note: This column originally appeared in the November 2013 issue of SMT Magazine.

Share

Print


Suggested Items

Northrop Grumman: 3D Nanomaterials May Counter Gaps in Additive Supply Chain

10/22/2020 | Andy Shaughnessy, Design007 Magazine
The best technology is dead in the water if your domestic supply chain won’t support it. That was just one of the takeaways from Dr. Judy Dickson’s talk during the SMTA Additive Electronics TechXchange. In her presentation, titled “Advanced PWBs: A Collaboration Between Design, Operations, and the Supply Chain,” Dickson, a senior principal systems engineer at Northrop Grumman Mission Systems, laid out the many challenges her department faces in fielding HDI advanced packaging into the next decade. Most of these challenges are related to sourcing the necessary materials in the U.S.

Increase Traceability, Prevent Counterfeiting

08/25/2020 | I-Connect007 Editorial Team
Michael Ford, senior director of emerging industry strategy for Aegis Software and I-Connect007 columnist, speaks about the increasing importance of traceability in manufacturing and throughout the supply chain, including how it affects such areas as counterfeit components and inventory management.

The iNEMI 2019 Board Assembly Roadmap

06/01/2020 | Pete Starkey, I-Connect007
iNEMI continues to publish chapters of its 2019 Roadmap and recently presented an overview of its Board Assembly Roadmap Chapter in a webinar prefaced by Grace O’Malley, vice president of global operations. The new chapter is just the latest addition to this global effort from 23 working groups contributing expert input from all aspects of the electronics industry.



Copyright © 2021 I-Connect007. All rights reserved.