Open Failure Analysis Lab Assessment Service Available


Reading time ( words)

Bhanu Sood describes the services offered by the Center for Advanced Life Cycle Engineering, and explains how physics-of-failure techniques are applied as a means of gaining a scientific understanding of reliability.

Watch the interview here.

Share

Print


Suggested Items

I-007e Micro Webinars Releases Part 4 in ‘Coatings Uncoated!’ Series

02/05/2020 | I-Connect007 Editorial Team
What is creepage, and how does it impact clearance? Can conformal coatings reduce creepage? The fourth episode of the popular webinar series, Coatings Uncoated, is now available to view. Author of The Printed Circuit Assembler’s Guide to Conformal Coatings for Harsh Environments and topic expert Phil Kinner from Electrolube shares highly focused educational information on conformal coating and encapsulation.

Tips & Tricks: Water Contamination and Flux Expiry

04/17/2019 | Jason Fullerton, MacDermid Alpha Electronics Solutions
Solder joints that form properly are not expected to exhibit reduced reliability. However, a higher number of defects created tends to lead to a higher chance that defective connections escape detection through inspection and functional testing, and that’s not a risk to be taken lightly.

Effect of Solder Composition, PCB Surface Finish and Solder Joint Volume on Drop-Shock Reliability

01/20/2017 | Jim Wilcox and Francis Mutuku, Universal Instruments Corp.; and Shuai Shao and Babak Arfaei, Binghamton University
Lead free solder joint reliability in drop shock loading has been a recurring issue in mobile and handheld consumer electronics. Changing solder composition may offer an opportunity to improve joint drop reliability. This study focuses on different failure modes in circuit board assemblies as observed based on solder composition, board surface finish, and solder joint volume.



Copyright © 2021 I-Connect007. All rights reserved.