ZESTRON’s Axel Vargas to Present in Manaus-AM, Brazil


Reading time ( words)

ZESTRON, the globally leading provider of high precision cleaning products, services and training solutions in the electronics manufacturing and semiconductor industries, is pleased to announce that Axel Vargas, Sales Engineer, will present “Improvements in Yield and Reliability for SMT Processes via Cleaning” at the Solder Metallurgy, Stencil Design and Process Optimization Workshop in Manaus-AM, Brazil on August 20th.

Trends within the electronics industry, including miniaturized components, increased board density and reduced standoff heights, are driving the need for high precision cleaning. This presentation discusses how to implement yield and reliability improvements to the SMT process via cleaning from print to final assembly.

This free one day workshop will be held at the Comfort Hotel Manaus, Mandíi Avenue, 263. Industrial District, Manaus – AM, Brazil, on August 20th, from 2:00 PM to 5:30 PM.  Immediately following the presentations, a complementary cocktail hour and reception will be held until 7:30 PM.  Registration is required for this learning event. For more information on ZESTRON Academy or to register, please visit our workshops page.

About ZESTRON

Headquartered in Manassas, Virginia, and operating in more than 35 countries, ZESTRON is the globally leading provider of high precision cleaning products, services and training solutions for the electronics manufacturing industry. With six worldwide technical centers and the largest team of chemical engineers in the industry, ZESTRON’s commitment to ensuring that its customers surpass even the most stringent cleaning requirements is without equal.

For additional information and to tour one of our unparalleled technical centers, please visit www.zestron.com.

Share

Print


Suggested Items

This Month in SMT007 Magazine—Continuous Improvement: As Simple as X = Xc – 1

01/04/2021 | I-Connect007 Editorial Team
X=Xc – 1 is a conceptual equation for continuous improvement. You define X and work to reduce it by a factor of 1. This could be one work hour, one process step, one day less in a cycle, and so on. We recently met with Dr. Ron Lasky to discuss the concept of X=Xc – 1 and get his advice on generating enthusiasm among readers and the next generation about continuous improvement. As this discussion illustrates, many process improvements are small in scale, not yearlong, major efforts.

Top 10 Most-Read SMT Articles of 2020

12/31/2020 | I-Connect007
As 2020 comes to a close, the I-Connect007 Editorial Team takes a look back at its most read articles. Here are the top 10 reads in SMT from the past year.

SMTA Europe Solder Finish Webinar Addresses Defects Causes and Cures

12/14/2020 | Pete Starkey, I-Connect007
“What is your most common PCB problem?” A survey conducted by Bob Willis had revealed finish solderability to be the predominant contender, and it was clear that the choice of solderable finish applied to surface mount boards could have a significant effect on the assembly yield and cost of the final circuit. SMTA Europe organised an informative and enlightening webinar this month entitled “Guide to PCB Solder Finishes—Process Defects Causes and Cures,” with soldering specialist Bob Willis as presenter.



Copyright © 2021 I-Connect007. All rights reserved.