A Thin Ribbon of Flexible Electronics Can Monitor Health, Infrastructure


Reading time ( words)

flex_electronics.jpgA new world of flexible, bendable, even stretchable electronics is emerging from research labs to address a wide range of potentially game-changing uses. The common, rigid printed circuit board is slowly being replaced by a thin ribbon of resilient, high-performance electronics. Over the last few years, one team of chemists and materials scientists has begun exploring military applications in harsh environments for aircraft, explosive devices and even combatants themselves.

Researchers will provide an update on the latest technologies, as well as future research plans, at the 250th National Meeting & Exposition of the American Chemical Society (ACS). ACS is the world’s largest scientific society. The meeting takes place here through Thursday.

“Basically, we are using a hybrid technology that mixes traditional electronics with flexible, high-performance electronics and new 3-D printing technologies,” says Benjamin J. Leever, Ph.D., who is at the Air Force Research Laboratory at Wright-Patterson Air Force Base. “In some cases, we incorporate ‘inks,’ which are based on metals, polymers and organic materials, to tie the system together electronically. With our technology, we can take a razor-thin silicon integrated circuit, a few hundred nanometers thick, and place it on a flexible, bendable or even foldable, plastic-like substrate material,” he says.

To allow electronics to be bendable or stretchable or even change their configuration after fabrication, the Wright-Patterson team has turned to liquid gallium alloys as an electrical interconnect material, Leever says. “While these liquid alloys typically oxidize within minutes and become essentially useless,” he says, “the team has been able to dramatically reduce the effects of the oxidation through the use of ionic species confined to the walls of microvascular channels within the flexible substrates.”

The result is thin, foldable material that allows the circuitry to fit into extremely tight spaces and even to be integrated into complex curved surfaces, such as an airplane’s wing, or even a person’s skin.

In aircraft applications, Leever explains, the hybrid flexible system can be used to monitor stresses and strains and report this information through miniature embedded antennas to ground crews or a pilot.

The researchers also are developing the same approach to monitor pilots’ health. This involves a biosensor system that can measure heartbeat, hydration levels, sweat, temperature and other vital signs through miniature circuitry. The system would be embedded on a flexible, wearable patch and would include an antenna to transmit these biometric signals to the pilot or a ground team. The patch will “breathe,” bend and stretch, and will provide real-time measurements of metrics that indicate fatigue or potential cognitive problems, Leever notes.

Another military application the Air Force is pursuing is use of a flexible hybrid system in “bunker buster” bombs, which detonate after penetrating deep in the earth. Because of the system’s toughness, Leever says, initial testing suggests that the flexible circuitry would remain viable and could detonate the weapon after surviving the initial impact of ground contact after being dropped from aircraft.

In the civilian world, Leever foresees use of flexible systems to monitor the conditions of bridges and other types of infrastructure in real time. He also points to medical applications, such as physical feedback for athletes as they exercise and real-time hospital monitoring for caregivers concerned about changes in a patient’s vital signs. This type of monitoring dispenses with the need for the bulky electrodes and wiring that normally are associated with close medical surveillance.

“Overall, the military has the advantage of being able to move ahead with potentially higher risk research,” he explains. “Commercial investors want a clear demonstration before making an investment. The military can pursue possibly transformational applications at earlier stages if we see a promising approach to realize and advance a technology’s revolutionary potential. When we are successful, the commercial sector directly benefits.”

Leever adds that the Wright-Patterson team is part of a newly created Department of Defense-led Flexible Hybrid Electronics Manufacturing Innovation Institute, which was announced by President Barack Obama last December. Over the next five years, $75 million will be offered in matching grants to spur domestic development of flexible hybrid electronics manufacturing.

The American Chemical Society is a nonprofit organization chartered by the U.S. Congress. With more than 158,000 members, ACS is the world’s largest scientific society and a global leader in providing access to chemistry-related research through its multiple databases, peer-reviewed journals and scientific conferences. Its main offices are in Washington, D.C., and Columbus, Ohio.

Share


Suggested Items

GP Ventures’ Tom Kastner on PCB Mergers and Acquisitions

10/10/2018 | Dan Beaulieu, D.B. Management Group
Tom Kastner, president of GP Ventures, he has his finger on the pulse of the industry's mergers and acquisitions (M&A) more than anyone. In this interview, Kastner provides insights on the right time to buy, how to evaluate your company's worth, and when it is too late.

PCBs Are Moisture-Sensitive Devices

09/07/2018 | Richard Heimsch, SUPER DRY
Research by SMT & Hybrid GmbH (now SMT Elektronik) was conducted just prior to the original publication of IPC-1601, which now provides detailed guidelines for the packaging and storage of PCBs, both from the PCB manufacturer and at the assembler’s manufacturing floor.

Reliability Takes on a New Urgency

09/05/2018 | Patty Goldman, I-Connect007
Consumers wanted a reliable car that wouldn’t break down on the road; a computer that wouldn’t crash; a phone network that wouldn’t drop our calls; the plane we were hurtling across the sky in to stay in the air and land safely, with the wheels down. In retrospect, those seem rather simple wants, and the industry certainly wants to deliver.



Copyright © 2018 I-Connect007. All rights reserved.