Reading time ( words)
When a new PCB design is born, designers envision what the product will provide when completed. Whether the product is for the consumer, aerospace, military, medical or countless other markets, the designers—or more likely, the customers—expect certain deliverables on the commodity they wish to purchase. To provide the desired functionality of the product design, engineers specify these deliverables on blueprints (prints) or fabrication drawings (fab drawings). These documents are the recipe for the manufacturing requirements of the given product.
A multitude of information is provided in these documents. In most cases the designers do not know the specific processes involved that satisfy their requirements, nor do they have to. They specify their requirements on the fab drawing and allow the PCB manufacturer to use the necessary processes to supply the final product, and herein lies the problem. Some complex designs could have fabrication drawings exceeding 20 pages, and may include requirements ranging from which raw materials are to be used to what type of anti-static packaging is required for shipping.
For this discussion, we will focus on how these documents pertain to electrical test (ET). In most fabrication drawings, many pages are graphical in nature and depict special dimensional or mechanical attributes, while others show drill/cutter requirements, plating requirements, special layup instructions, and almost always a note(s) page. Should ET read the entire package? Yes. Why? Because many times there can be mechanical attributes that will influence how the final product can be tested.
Read the full article here.
Editor’s Note: This article originally appeared in the January 2016 issue of The PCB Magazine.
Share
Suggested Items
03/07/2023 |
I-Connect007 Editorial Team
In this interview, Saline Lectronics (an Emerald EMS company) President Jason Sciberras talks about PCB designers offering packaging options in the bill of materials. As Jason explains, mil/aero manufacturers like Saline can’t make many changes to a design without getting recertified, so including approved packaging options in the BOM from the start is a great way to go. Are you offering options in your BOM?
01/20/2023 |
Andy Shaughnessy, Design007 Magazine
We’re in the middle of show season, and it certainly “shows.” Thank you very much. I’m here all week. Don’t forget to tip your wait staff. This week, we published a variety of articles, columns, and news items, and much of it centered on trade shows. Technical Editor Dan Feinberg brings us a report from CES 2023. IPC announced the winners of the Best Technical Paper awards for IPC APEX EXPO 2023. And we have an interview with Altium’s Rea Callender about the company’s educational efforts at APEX and around the globe.
12/29/2022 |
Andy Shaughnessy, Design007 Magazine
While it may be traditionally considered a PCB fab and assembly show, IPC APEX EXPO is quickly becoming a destination for PCB designers and design engineers. Flipping through this year’s schedule, I counted 15 Professional Development and Technical Conference classes that focus on PCB design, as well as several fabrication classes that many of you should probably take. I checked in with Carlos Plaza, IPC’s senior director of educational development, to discuss the organization’s drive to present more PCB design curriculum at the upcoming show and how the show can give designers the tools they need to overcome the many challenges currently facing the industry.
