IPC APEX EXPO: Isola Introduces New Products, Increases R&D


Reading time ( words)

Ed Kelley, VP of global technology, sits down with Guest Editor Dan Beaulieu at IPC APEX EXPO to discuss the company's plans for the future. The company is launching new low-loss laminates and increasing its R&D activities around the globe.  He also explains why Isola often works with designers at OEMs, and what he sees in the global PCB laminate market.

To watch this interview, click here.

Share


Suggested Items

Advanced Stackup Planning with Impedance, Delay and Loss Validation

08/02/2018 | Yuriy Shlepnev, Simberian
A typical PCB design usually starts with the material selection and stackup definition—the stackup planning or design exploration stage. How reliable are the data provided by the material vendors and PCB manufacturers? Can we use these data to predict trace width and spacing for the target trace impedance or to calculate delays or evaluate the loss budget?

Design and Manufacturing Perspectives from DISH Technology’s Les Beller

05/30/2018 | Barry Matties, I-Connect007
I recently interviewed Les Beller, a long-time PCB designer who is now a manufacturing engineer for DISH Technology. We discussed his company’s business shift towards 5G and streaming, and the stresses that puts on a design team. He also explains the greatest challenges that he’s facing with HDI and higher frequencies, and the added importance for designers to understand the manufacturing process and DFM tools.

ITEQ Ready for Autonomous and Electric Vehicles of the Future

05/23/2018 | Andy Shaughnessy, Design007 Magazine
During DesignCon 2018, I spoke with Tarun Amla, the executive vice president and CTO of ITEQ. We discussed ITEQ’s future plans, including the development of materials for cutting-edge technology needs, such as autonomous and electric vehicles, as well as 5G technology.



Copyright © 2018 I-Connect007. All rights reserved.