Development of Circuit Technology that Resolves Issues with High-Frequency Piezoelectric Resonators
June 20, 2016 | NICTEstimated reading time: 1 minute
In collaboration with the National Institute of Information and Communications Technology (NICT), Associate Professor Hiroyuki Ito and Professor Kazuya Masu, et al., of the Tokyo Institute of Technology, developed a new algorithm and circuit technology allowing high-frequency piezoelectric resonators to be used for phase locked loops (PLL). It was confirmed that these operate with low noise and have an excellent Figure of Merit (FoM) compared to conventional PLLs.
This technology allows high-frequency piezoelectric resonators to be used in place of crystal oscillators which was a problem for realizing compact and low-cost radio modules. This greatly contributes to the creation of compact, low-cost, high-speed radio communication systems for the IoT age. High-frequency piezoelectric resonators are compact, can be integrated, have an excellent Q value, and oscillators that use these have excellent jitter performance. High-frequency piezoelectric resonators had greater issues with resonance frequency variance and temperature dependability compared to crystal resonators. However, these issues were resolved by the development of a PLL that uses a channel adjustment technique, which is a new algorithm.
A prototype was fabricated by a silicon CMOS process with a minimum line width of 65 nm, and a maximum frequency output of approximately 9 GHz was achieved with a phase fluctuation of only 180 femtoseconds. Power consumption was 12.7 mW. This performance is equivalent to a PLL Figure of Merit (FoM) of -244 dB, and it has the world’s top-class performance as a fractional-N PLL. This can contribute to the realization of compact, low-cost, high-speed radio communication systems.
The study results will be announced in local time June 17 in "The 2016 Symposium on VLSI Circuits" to be held in Hawaii from June 14.
Suggested Items
Boeing Opens Research & Technology Center in Japan
04/23/2024 | BoeingBoeing today opened a Boeing Research & Technology (BR&T) Center in Japan that will focus on innovation to enable the commercial aviation industry meet its goal of net zero carbon emissions by 2050.
Schweizer Electronic Appoints Thomas Gottwald as New Member of the Executive Board
04/23/2024 | Schweizer Electronic AGThe Supervisory Board of Schweizer Electronic AG has appointed Mr. Thomas Gottwald to the Executive Board as CTO (Chief Technology Officer) for a period of 3 years with effect from 1 May 2024.
US Department of Defense Selects Intel Foundry for Phase Three of RAMP-C
04/23/2024 | IntelThe U.S. Department of Defense (DoD) has awarded Intel Foundry Phase Three of its Rapid Assured Microelectronics Prototypes - Commercial (RAMP-C) program.
Real Time with... IPC APEX EXPO 2024: Industrial Quality Solutions from Zeiss
04/23/2024 | Real Time with...IPC APEX EXPOEditor Nolan Johnson and Herminso Gomez of Zeiss Group discuss the company's industrial quality solutions, with a focus on X-ray technology. Zeiss provides a range of microscopy options and Herminso highlights the advantages of X-ray technology for aerospace, medical, and consumer electronics sectors.
AIM Solder’s Dillon Zhu to Present on Ultraminiature Soldering at SMTA China East
04/22/2024 | AIMAIM Solder, a leading global manufacturer of solder assembly materials for the electronics industry, is pleased to announce that Dillon Zhu will present on the topic: Ultraminiature Soldering: Techniques, Technologies, and Standards at SMTA China East. This event is being held at the Shanghai World Expo Exhibition & Convention Center from April 24-25.
Copyright © 2024 I-Connect007 | IPC Publishing Group Inc. All rights reserved.
Log in