Getting Signal Integrity Right by Design


Reading time ( words)

As clock frequencies increase and active devices and interconnect traces shrink and are placed ever closer together, signal integrity (SI) becomes an increasing challenge. Today, SI is typically addressed late in the design process after the PCB layout has been completed by performing complex and time-consuming 3D extractions and simulations for high-speed lines.

But with little attention being paid to SI during the layout process, simulation frequently identifies numerous SI problems. Multiple design and simulation iterations are often required to resolve these issues, in some cases causing delays in bringing the product to market and increasing nonrecurring expenses. An embedded SI checker helps by automatically checking for common mistakes that frequently cause SI problems such as missing shielding, return path discontinuities, ground or power loops, impedance mismatches, etc. Even with this approach, simulations are still required as a final check, but reducing the number of issues that must be addressed at this late stage helps bring the product to market faster and reduces engineering costs.

SI Design Challenges

Increasing data rates, higher IO counts and greater design complexity are leading to greater challenges in meeting SI and electromagnetic interference (EMI) requirements. For instance, 3DIC technology utilizes through-silicon vias (TSVs) to eliminate bond wires and further reduce interconnection distance in stacked chip configurations, providing higher speed performance and lower power consumption at the cost of creating many new opportunities for harmful radiation. Meanwhile, regulatory authorities are tightening electromagnetic compatibility (EMC) requirements by requiring compliance at higher and higher frequencies. The trend towards integrating multiple radios—each of which is an intentional radiator—into electronic products creates further challenges.

But the complexity of today’s designs and the high levels of automation required to complete them in a reasonable time period usually prevent electrical designers from paying more than cursory attention to SI during the design process. Nearly all PCB design tools have built-in design rule checkers (DRCs) but they typically evaluate the design from a manufacturability perspective, rather than from an SI perspective. Simulation is normally performed after the design has been completed, when it becomes possible to model its performance by calculating a 3D solution of Maxwell’s equations, which provides an elegant mathematical representation of electromagnetic interactions. The result, all too often, is that large numbers of SI problems are identified at a point relatively late in the design process when changes are very expensive to make. As a general rule, the cost of design changes generally increases by an order of magnitude or more as the design moves from conceptual to detailed to simulation.

To read this entire article, which appeared in the July 2016 issue of The PCB Design Magazine, click here.

Share

Print


Suggested Items

Altium Prepares for Munich Show as Growth Continues

01/17/2019 | Andy Shaughnessy, Design007 Magazine
It’s been just two months since the AltiumLive event drew several hundred designers to San Diego, California, and Altium is already gearing up for the next show in Munich, Germany (January 15–17, 2019). I recently spoke with Chris Donato, VP of global sales for Altium, about the upcoming AltiumLive show as well as the company’s growth over the past few years.

January 2019 Issue of Design007 Magazine Available Now

01/15/2019 | I-Connect007
The component shortage is getting crazy. Some PCB designers are finding their favorite capacitors on 50-week and 80-week lead times, or worse. How do you design a board today when the components you need won’t be available for a year or more? In the January 2019 issue of Design007 Magazine, we asked our expert contributors to explain the current component shortage, as well as some of the workarounds that can help you get your next design out the door sooner rather than later.

A Fractal Conversation with Jim Howard and Greg Lucas

01/15/2019 | Barry Matties and Andy Shaughnessy, I-Connect007
Veteran PCB technologists Jim Howard and Greg Lucas have made an interesting discovery: Certain shapes of copper planes make a PCB run more efficiently than other shapes, a process they dubbed fractal design. It doesn’t appear to cost a penny more, and testing suggests that fractal design techniques could eliminate edge noise. Barry Matties and Andy Shaughnessy asked Jim and Greg to discuss the fractal design process, and the advantages of using this technique.




Copyright © 2019 I-Connect007. All rights reserved.