Tackling the Challenges in Flex Assembly


Reading time ( words)

We recently released the inaugural issue of Flex007 Magazine, which is dedicated to flex system designers, electrical engineers, flex PCB designers, and anyone responsible for integrating flex into their products at the OEM/CEM level. (If you haven’t seen the first issue yet, which features some of the top flex experts sharing thoughts about flex, rigid-flex, and the flex market, click here.)

As my colleague and Flex007 Managing Editor Andy Shaughnessy wrote, it was time to expand our Flex007 Weekly Newsletter into a magazine after seven years due to the increasing use of flex circuits in many electronics applications.

Indeed, the flex printed circuit market continues to be one of the fastest-growing segments of the PCB industry. According to a report by industry analysts Transparency Market Research (TMR), the global market for flexible printed circuits is expected to expand at a CAGR of 11.8% to reach a value of $38.27 billion by 2026, up from about $14.51 billion in 2017. Mainly driving this growth is the significant rise in the consumer electronics industry, led by the growing demand for smartphones, tablets, and LCD displays. Meanwhile, multilayer flex circuits are enjoying a greater demand among products in this sector, and this trend is projected to remain so over the next few years, according to TMR.

While we were planning the launch of Flex007, one of the flex experts we spoke with mentioned that apart from the design and manufacturing of flex printed circuits, a critical challenge that needs attention is assembly. Their flexible nature requires specific strategies for paste printing, chip mounting, soldering—whether reflow, wave, or hand—and rework/repair processes. Which is why, for the June 2018 issue of SMT007 Magazine, we investigate the many challenges in flex circuit assembly and highlight some of the strategies, techniques and best practices to help assemblers deal with flex circuit issues.

To read the full version of this article, which appeared in the June 2018 issue of SMT007 Magazine, click here.

Share


Suggested Items

Tackling Reliability Challenges in Low-Temperature Soldering

07/18/2018 | Barry Matties and Stephen Las Marias, I-Connect007
William Yu, senior technical services manager for Alpha Assembly Solutions, recently shared with I-Connect007 the challenges when it comes to the reliability of low-temperature solder pastes, and soldering strategies to overcome these issues.

Nearing Retirement, Juki's Bob Black Reflects on a Long Career

07/17/2018 | Barry Matties, I-Connect007
After more than 40 years in the electronics manufacturing industry, Juki's Bob Black is nearing retirement. Bob sat down with Barry Matties at the recent SMT Hybrid Packaging show in Nuremberg to reflect on his career and talk about the importance of strategic partnerships, even if that means playing nice with your competitors.

Reflow Perspectives to Flex Circuit Assemblies

07/13/2018 | Stephen Las Marias, I-Connect007
At the recent NEPCON China 2018 event in Shanghai, I spoke with Ralf Wagenfuehr, plant manager at Rehm Thermal Systems, to gain insight into flex circuit assembly, and the challenges of reflow soldering. He also speaks about the need for industry forums focused on soldering flex printed circuits.



Copyright © 2018 I-Connect007. All rights reserved.