RTW IPC APEX EXPO 2019: Limata Unveils Exciting Developments in LDI


Reading time ( words)

Lino Sousa, sales, Limata, explains to Pete Starkey the latest developments in Limata’s laser direct imaging technology, which eliminates the need to change the solder mask. With this technology, Sousa says black solder mask and green solder masks look the same to the UV. Sousa says there is a system in qualification for two years now, and that they will start installation in March in North America.

To watch the interview, click here.

Share

Print


Suggested Items

Solder Mask Tack Dry

11/08/2019 | Nikolaus Schubkegel
As a general rule, the tack-dry temperature should be as low as possible; in other words, it should only be as high as necessary. If the temperature is too low, the evaporation rate for the solvent will be to slow, and the solder mask will not dry in a reasonable amount of time. If the temperature is too high, however, the dry time certainly will be excellent, but it could create a solder mask lock-in with repercussions by the developing time.

Communication, Part 4: The Top 5 Causes of Engineering Delays

10/25/2019 | Steve Williams, The Right Approach Consulting LLC
In Part 4 of this series on how PCB fabricators and designers can better communicate, Bob Chandler from CA Design and Mark Thompson from Prototron Circuits address the top five causes of engineer delays.

New High-speed 3D Surface Imaging Technology in Electronics Manufacturing Applications

10/09/2019 | Juha Saily, Focalspec Inc.
Line confocal sensors—and scanners based on them—are used in the imaging of surfaces, transparent materials, and multi-layered structures in various metrology and inspection applications on discrete parts, assemblies, webs, and other continuous products. Line confocal sensors operate at high speed and can be used to scan fast-moving surfaces in real-time as well as stationary product samples in the laboratory.



Copyright © 2019 I-Connect007. All rights reserved.