Wi-Fi 6: Wired vs. Wireless


Reading time ( words)

We all know that it makes no sense to get the latest device just because they come out with a new one every year. Sure, post-millennials tend to want a new phone every year, but most of us are well past that. However, as the competitive nature of the consumer tech industry continues to increase, the rate of change is also accelerating, as is the peer pressure to upgrade. Non-techies get new phones every year, techies get new CPU and GPUs every two years, average consumers get bigger and higher-res TVs every three years, and on it goes.

Sometimes, it does make sense to upgrade. However, a few years back, upgrading to a new modem/router using the new (at that time) DOCSIS 3.1 standard made sense, as it allowed high-speed cable data to potentially reach download speeds of up to 10 Gbps; this would greatly improve a wide variety of online experiences and abilities that have become a part lives, such as 4K video streaming, high-resolution multi-channel video conferencing, and multi-player online gaming. With the advent of 5G and all that it will enable, faster internet transfer speeds will become more than a want; for many 5G-enabled activities, those speeds will become necessary.

Before we discuss what you can expect from the next generation of internet connection, let’s first consider wired vs. wireless. As someone who usually uses wireless for net connection for notebooks, tablets, and phones and wired for my main rigs, let me categorically state that using wired is always better than wireless. I use large desktop computers as our main workstations because I want the high-speed, rapid ability to transform and transfer files (e.g., copying over a 45-minute 4K HiFi sound video from my NVME SSD PCIE4 workstation took under four minutes, while doing the same thing on my standard notebook takes just under an hour) and extreme multitasking. On these workstations/desktops, I use wired internet. Here are three main reasons why.

To read this entire article, which appeared in the December 2019 issue of PCB007 Magazine, click here.

Share

Print


Suggested Items

I-Connect007 Editor’s Choice: Five Must-Reads for the Week

02/05/2021 | Nolan Johnson, I-Connect007
Another active news week in the electronics industry! February is launching with a high-G burn, to be sure. And if you’re a fan of The Expanse, like I am, then you’ve probably already watched through to the Season 5 finale; this means you have attention to spare for industry news all of a sudden. And if you haven’t reached the current end of the line for The Expanse, then today’s list is just what you need while you catch up.

EIPC Technical Snapshot: PCB Surface Finishes

12/28/2020 | Pete Starkey, I-Connect007
For the third in a series of Technical Snapshot webinars, EIPC chose to focus on PCB surface finishes, comparing specific properties, examining corrosion behaviour and discussing selection criteria for low-loss, high frequency applications.

ECWC15 Virtual Conference Keynote: 5G PCB Technology and Material Challenges

12/07/2020 | Pete Starkey, I-Connect007
The second day of the Electronic Circuits World Convention began with a keynote from Dr. Shiuh-Kao Chiang, managing partner of Prismark, describing the PCB technology and material challenges presented by the introduction of the fifth-generation cellular wireless communication network—the roll-out of which was continuing in spite of the coronavirus pandemic. Technical Editor Pete Starkey has more.



Copyright © 2021 I-Connect007. All rights reserved.