We Saw This Coming


Reading time ( words)

There have been quite a few predictions and studies, along with plenty of wishful thinking, about the cost of manufacturing in the U.S. The onshoring/re-shoring movement has gained a lot of attention from media like ours over the last couple of years. IPC even issued a report last year providing their take on the movement, which garnered a lot of interest from the industry.

Now, The Boston Consulting Group (BCG), a global management consultant, has released new research on the “dramatic” change of manufacturing cost competitiveness around the world. BCG’s press release is entitled, “Study Reveals Striking Shifts in Global Manufacturing Costs over the Past Decade.” I found the use of the word “striking” to be interesting. It almost leads me to believe they were surprised by the trends in manufacturing costs.

For those of us watching the shift over the last few years, it isn’t striking at all. It’s been coming for some time. As I’ve said in the past, all things come back into balance. The rising costs in Asia, and China in particular, have made it very clear that you can only sustain dirt-cheap manufacturing for so long. At some point, lax or non-existent labor and environmental standards, ridiculous lending policies, manipulated currencies, etc., will yield a day of reckoning. People get tired of breathing bad air and drinking polluted water. Trading partners say “enough is enough” and demand fair currency valuations. And banks struggle to survive under the weight of bad loans made during the heady days of unbridled growth.

Read the full column here.


Editor's Note: This column originally appeared in the June 2014 issue of SMT Magazine.

Share


Suggested Items

PCB Pad Repair Techniques

01/08/2018 | Bob Wettermann, BEST Inc.
There are a variety of reasons behind pads getting "lifted" completely or partially from the laminate of a PCB. Per the just revised IPC-A-610 Revision G, a defect for all three classes occurs when the land is lifted up one or more pad thicknesses. Lifted pads can occur when a device has been improperly removed or there is a manufacturing defect in the board construction. In any case, as with any repair, the ultimate decision on the ability to repair the pad lies with the customer.

Focus on the New

01/05/2018 | Stephen Las Marias, I-Connect007
It seems like it wasn't too long ago when I was writing about the optimism of the electronics manufacturing and assembly industry going into 2017. Now, here we are again at the beginning of the new year, looking at new trends, disruptive technologies, and emerging markets for 2018. I am also proud to announce our new branding as well as our fresh, new look.

Top 10 Most-Read SMT Articles of 2017

12/29/2017 | I-Connect007
Every year, we like to take a look back at the most popular SMT news and articles. These are the top 10 most-read SMT articles from the past year.




Copyright © 2018 I-Connect007. All rights reserved.